Aberdeenshire · Scotland
Lighting bollard installation in Fraserburgh
Lighting bollards for sites across Fraserburgh and the rest of Aberdeenshire, from the first measurement to the last relaid paving block.
Computer-generated imageFraserburgh lighting bollards
Across Fraserburgh, typical sites for lighting bollards include community car parks, community buildings and residential driveways. Outdoor lighting bollards need weatherproof and impact-resistant construction and must be connected and tested by a qualified electrician.
We work across AB43 — Fraserburgh itself and places including Rosehearty, Inverallochy, Strichen and St Combs. Jobs in Fraserburgh can be combined with work in Peterhead (15.3 miles) (straight-line distances).
Fraserburgh at a glance
- Area
- Aberdeenshire, Scotland
- Roads authority
- Aberdeenshire Council (local roads)
- Planning authority
- Aberdeenshire Council
- Postcodes
- AB43
- Guide price
- Typically £345–£1,195 per bollard + VAT (£405–£1,445 inc VAT for homes); minimum job £845
- Survey
- Free, with a fixed written quote
- Nearby
- Peterhead (15.3 mi)
Guide prices for Fraserburgh
| Specification | Guide price | Includes |
|---|---|---|
| Standard | £345–£705 + VAT · £405–£845 inc VAT | Standard post, foundation, reinstatement |
| Upgraded | £605–£955 + VAT · £725–£1,145 inc VAT | Upgraded finish or fittings, reflective band, matched keys |
| Premium | £855–£1,195 + VAT · £1,045–£1,445 inc VAT | Heavy-duty or architectural spec, premium finish |
Per bollard, installed with a qualified electrician (supply run extra); no regional adjustment. Guide only — the fixed price follows a survey.
Where lighting bollards go in around Fraserburgh
Typical reasons Fraserburgh sites choose lighting bollards:
- Parks and areas where tall columns would be intrusive
- Footpaths through housing developments and campuses
- Steps, ramps and changes in level
What we check first in Fraserburgh
In Scotland the council is the roads authority for local roads, which in Fraserburgh means Aberdeenshire Council. Lighting bollards on an adopted footway need its consent; trunk roads sit with Transport Scotland.
If your site in Fraserburgh is listed or inside a conservation area, check with the local planning authority (Aberdeenshire Council) before choosing a finish — heritage settings often favour cast iron or painted steel over stainless.
Cable trenches run between every position and back to the supply, often crossing paths, drives and planting, so the routes are planned to minimise cuts through hard surfaces and to avoid existing gas, water and telecoms services. Most of the work in a lighting bollard scheme is underground.
- Where bollards light a public route, check the lighting levels the site owner or designer requires.
- Limit glare and upward light, and check for any planning or ecology conditions on lighting near sensitive habitats.
How the job runs
Dig cable routes
Trenches are dug between bollard positions and the supply point, avoiding existing services, with cable or duct laid at a suitable depth and warning tape above.
Set the bases
Anchor cages or foundations are cast at each position with the cable entry in the right place, set level so each bollard stands plumb.
Reinstate
Trenches are backfilled and surfaces made good, whether paving, tarmac, gravel or turf.
Specification choices
| Option | Detail |
|---|---|
| Solar bollards | Self-contained with panel and battery; no cabling. Suited to markers and low-use routes where lower output is acceptable. |
| Body materials and finishes | Powder-coated aluminium or steel, or stainless steel, in colours to suit the building. |
| Mains LED bollards | Wired from a dedicated circuit for reliable lighting of paths and car parks. Needs cable routes and electrical certification. |
What moves the price in Fraserburgh
Two Fraserburgh jobs with the same number of posts can price quite differently. The usual reasons:
- Controls such as photocells, timers or sensors
- Mains or solar bollards
- Reinstatement of paving, tarmac or planting
After installation
LED lighting bollards need far less maintenance than older lamp types, but they are not maintenance-free. If a run of bollards trips the circuit after rain, water ingress at a connection is the usual cause and needs an electrician.
If posts in Fraserburgh are later hit or damaged, we can repair or replace them — see bollard repairs.
Questions about lighting bollards in Fraserburgh
Which parts of Fraserburgh do you cover for lighting bollards?
We cover all of Fraserburgh (AB43) and the rest of Aberdeenshire. We also work in Peterhead.
Who gives permission for bollards on the pavement in Fraserburgh?
In Scotland the council is the roads authority for local roads, which in Fraserburgh means Aberdeenshire Council. Lighting bollards on an adopted footway need its consent; trunk roads sit with Transport Scotland.
What's a typical price for lighting bollards in Fraserburgh?
In Fraserburgh, typically £345–£1,195 per bollard, installed with a qualified electrician (supply run extra), plus VAT (£405–£1,445 including VAT for homeowners), with a minimum job of £845 plus VAT, using our Scotland guide prices. The fixed figure comes in writing after we've seen the site.
Are solar bollard lights worth it?
For marking edges and low-use paths, they can be, because there is no cabling to install. They give less light than mains bollards and perform poorly in shaded spots and short winter days. For lighting a route properly, mains bollards are more dependable.
Can bollard lights work on a timer or motion sensor?
Yes. Photocells switch them on at dusk, timers switch them off or dim them late at night and motion sensors bring them up when someone approaches. Combining controls saves energy and reduces light pollution.