Hampshire · England
Shallow-mount security bollard installation in Bordon
Planning shallow-mount bollards in Bordon? We check ownership, consents and buried services first, then quote a fixed price.
Computer-generated imageShallow-mount bollards in Bordon
In the town of Bordon, shallow-mount bollards tend to go in at high street shopfronts, small industrial units and community car parks. Like any rated product, its performance applies only to the configuration and foundation that were tested.
We cover Bordon's GU35, GU30, GU33 and GU34 postcode districts, including places such as Headley Down, Lindford, Arford and Standford. We also cover neighbouring Farnham (7.5 miles), Aldershot (10.2 miles), Fleet (11.8 miles) and Godalming (11.8 miles) — distances are straight-line. It sits roughly 24 miles from Portsmouth as the crow flies.
Key facts for this area
- Area
- Hampshire, England
- Highway authority
- Hampshire County Council (local roads)
- Planning authority
- the council for East Hampshire
- Postcodes
- GU35, GU30, GU33 and GU34
- Guide price
- Typically £2,095–£9,545 per bollard + VAT; minimum job £5,295
- Survey
- Free, with a fixed written quote
Bordon: typical shallow-mount bollard prices
| Specification | Guide price | Includes |
|---|---|---|
| Standard | £2,095–£5,245 + VAT | Rated for a 7.5 t vehicle at 30 mph (48 km/h), tested foundation |
| Upgraded | £4,345–£7,445 + VAT | Rated for 7.5 t at 40 mph (64 km/h), tested foundation |
| Premium | £6,545–£9,545 + VAT | Rated for 7.5 t at 50 mph (80 km/h), or a specialist foundation |
Per bollard position, supplied and installed; +6% for South East. Guide only — the fixed price follows a survey.
Where shallow-mount bollards go in around Bordon
Common uses in a place like Bordon:
- Footways with dense utility runs just below the surface
- Bridges and structures where excavation depth is limited
- Retrofits outside occupied buildings with tight programmes
Consents, ground and services in Bordon
The highway authority for local roads in Bordon is Hampshire County Council; motorways and trunk roads sit with National Highways. Shallow-mount bollards on the adopted footway are a matter for the highway authority, so we only install there with its written agreement.
Bollards on private land often don't need planning permission, but it depends on the council's view, the height and the location; in a conservation area, next to a listed building or under an Article 4 direction, ask the local planning authority (the council for East Hampshire) first — we flag this at survey.
Paving is often natural stone in the streets where these systems are used, so careful lifting, storage and relaying is part of the job. Utility owners may set minimum separation distances or ask to be present when digging near their apparatus.
- Agree works and separation distances with utility owners, and with the highway authority where the line is on public highway.
- Get written confirmation from a structural engineer before installing on slabs, decks, basements or over voids.
Installation, step by step
Confirm the system with the manufacturer
The survey findings go back to the manufacturer and the client's adviser to confirm the system, its layout and any end details. A fixed written quote follows the free site survey.
Cut and excavate the trench
Paving is lifted and kept for reuse where possible, and a shallow trench is excavated by hand near known services. Where a service sits higher than expected, work stops and the detail is referred back.
Record and hand over
As-built drawings show the frame position relative to services, which matters for anyone digging nearby later. Product certificates and photographs go to the client's adviser.
Options to consider
| Option | Detail |
|---|---|
| Rated planters and street furniture | Benches, planters and cycle stands built around a tested shallow core, used where a line of posts would look out of place. |
| Modular cassette sections | Pre-made sections joined on site, allowing short runs and changes of direction within the manufacturer's tested limits. |
| Surface-mounted rated units | Some tested products sit on or very close to the surface with minimal digging. These are often used for temporary or semi-permanent protection and need careful checking of the surface they bear on. |
What moves the price in Bordon
Our South East guide prices are a starting point; the survey in Bordon firms them up. What tends to move them:
- Length of run and the system needed to achieve the rating
- Structural engineering checks on slabs or decks
- Restricted working hours in busy streets or occupied sites
Keeping them working
Any later utility work beside the line should be supervised so the frame is not undermined. Pay attention to the surface around the posts, because settlement or loose paving can indicate movement in the bearing layer.
If posts in Bordon are later hit or damaged, we can repair or replace them — see bollard repairs.
Questions about shallow-mount bollards in Bordon
Which parts of Bordon do you cover for shallow-mount bollards?
We cover all of Bordon (GU35, GU30, GU33 and GU34) and the rest of Hampshire. We also work in Farnham, Aldershot and Fleet.
Do I need consent for shallow-mount bollards on a public footway in Bordon?
Hampshire County Council is the highway authority covering Bordon's local roads. If any post would stand on adopted highway rather than your land, that consent is the first thing we sort out.
What's a typical price for shallow-mount bollards in Bordon?
In Bordon, typically £2,095–£9,545 per bollard position, supplied and installed, plus VAT, with a minimum job of £5,295 plus VAT, using our South East guide prices. The fixed figure comes in writing after we've seen the site.
Can I install a single shallow-mount bollard on its own?
Usually not. Most shallow systems rely on several posts working together, and the rating applies to a tested run with a stated minimum number of posts. A single position generally needs a different solution.
Does a shallow system protect as well as a deep one?
It can achieve the same rating, because both are tested to the same standards. What differs is how the load is resisted. Your security adviser should compare the specific ratings, not the foundation depths.
Shallow-mount bollards near Bordon
- Farnham (7.5 mi)
- Aldershot (10.2 mi)
- Fleet (11.8 mi)
- Godalming (11.8 mi)
- Farnborough (13.3 mi)
- Basingstoke (14.2 mi)